Meade Telescopes Eyepieces

Thu, 07 Oct 2010 00:29:10 +0000

meade Telescopes eyepieces

I have a Meade DS 2000 telescope reflector, and I can not see anything through the eyepiece. Help?

There was a door on one end that I took off, but do not know what to do to solve this problem. There is no light coming through. I do not know how to use it at all, videos of the manufacturer does not help. Ideas for what to do?

Look in the manual on the diagram to be sure you have prepared properly:. Review how to place the eye of Mead: 10. Place the viewfinder: Carefully remove the rubber eye cup viewfinder before sliding the viewfinder in the bracket. Slide the viewfinder, close eye first, in supporting the display (see fig. 8a and 8b). Replace the rubber eye after the viewer is placed in the holder. Tighten the four alignment screws (8, Fig 1.) A company feels to hold the scope in the cradle. 11. Connect the 90 ° diagonal prism 12: Insert the eyepiece: Remove the eyepiece supplied by the eyepiece holder 2 (, (5, fig. 1) of its container and place it on the diagonal of the prism directly Fig. 1) (only models reflector). Tighten the screw (2, Fig 1.) A company can only feel. 13. Insert the batteries: The battery compartment telescopes (. 1, Fig 10) is in the top of the base of the unit. Open the battery compartment by lifting the cover and throw away the basis of unity:. D-This is a good telescope. Quiet and figure out.

Backyard Clouds

No items matching your keywords were found.

Powerful Telescopes » Eyepiece

Meade Telescopes Eyepieces